Receiver’s functioning
Receiver is supplied with 8relays outputs with common contacts (Please check wiring diagram); common contact must be connected to positive or negative pole, according to thepolarity of the load connected;In order to avoid overload due to short circuit, put in a 6A fuse. When you turn on the receiver, the green led LINE blinks few timesand after 1 sec. the red led for programming turns on as well.The red led keeps turned on for about 15 sec., during this time the receiver is enabled to receive a new transmitter’s code and to memorize it. It is possible to store up to 5 transmitters at the same time; whenever more than 5 transmitters are memorized, the receiver accepts thelatest code cancelling the first code received. When the red led is turned off you cannot make any TX memorizing procedure;The pressure of one button on the transmitter turns on the corresponding yellow led on the receiver and the operating of theoutput that is concerned;
Programming Procedure
After powering the receiver when the red led is turned on steady follow these steps:1.Turn the new transmitter on, pressing the button ON;2.Keep the button DOWN_LEFT;3.Press the button PROGR on the receiver;4.Releasethe button DOWN_LEFTof the transmitter;5.If the code has been recognized the led blinks in succession four times, then it turns off in order to confirm that the new transmitter has been memorized;6.Verify the correct functioning of the new transmitter ;Inorder to add a new transmitter to a device that you already use, turn the receiver on and follow this procedure:Press and keep pressed the button PROG on the receiver as long as the red led turns on, then release it.Repeat the procedure starting from step 1
Battery replacement
Unscrew the 6 screws on the transmitter’s back and take the rear part of the box away;Replace the batteries employing exclusively 1.5V AA batteries. Please respect thepolarity; reversing batteries doesn’t damage the transmitter, but stops its functioning;Position the rear cover and screw the closing screws.
Connecting the optional external antenna
Open the receiver and remove the internal antenna from the terminal board;Cut the cable at the necessary length and keep it as shortest as possible;Run the cable of the external antenna in the hole already made and connect it to the terminal board: the cable shield must beconnected to the GND contact, and the radio signal wire to the ANT contact:Close the receiver and fix the antenna to the boat loom by usingthe flat washer and the nut given in equipment.
